EPDM Rubber U Channel Profile Trim Car Vehicle Window Door Edge Weatherstrip

Material: EPDM

Color:black, gray, yellow, red or as customer's required

Hardness: According to your requirement

The Property of rubber U Channel Profile

A: High flexible and plasticity, anti-aging, ozone and chemistry resistant, wearing-resistant.

B: Using range of temperature (minus 70 degree to 280 degree)

C: Without steel or wire in the core, also without glue.

No messy glue, sealant or permanent fixtures needed

D:It is easy and fast to install.

Just press on for a snug super tight grip, the flexible trim is metal lined 

and has inner lips to provide a secure fitment

E:Good looking (decorative), good sealing capacity and effective edge protection

Why you choose rubber U channel profile from us?

Because the detail of rubber U channel profile are below

1.Excellent raw material

Imported rubber raw material,Gloss Appearance , long service life

2.High elasticity 

Flexible enough to bend randomly

3.Multiple specifications and get optional randomly

The install place:

Seals the interior and exterior to prevent water, debris, and white-noise intrusion Fits edges:

See the picture show.

Easy install

Just push on the rubber seal above the install place.

The rubber seal will be griping around the edge without adhesive or any other thing 

Functions:

Reduce the impact of the doors, extend the service life.

Seal the door gap, prevent muddy water coming.

Reduce wind noise, create a quiet environment.

Prevent the exposed air, make more comfortable riding.

Application Range of Rubber U Channel

The trims provide a permanent grip on the trim covers a huge variety of uses including: car,

camper, truck, boat, mini-van, van, trailer, bus, coach, lorry, motor home, caravan, truck, general

engineering and domestic use. Fitting cars such as - Mini, Ford, Hillman, Vauxhall

VW, Land Rover, Peugeot, Citreon, BMW, Mercedes, Porsche etc

Note:

Please measuring your car before buying the product

Please allow minor error due to manual measurement.

Due to the difference between different monitors

the picture may not reflect the actual color of the intem

The steps of installation

1. Clean up the installation location

2. Apply the adhesion promoter to the inside of the door

3. Rip the internal tape

4. Paste on the edge of the door

5. Pulling and pressing

6. Lose the extra parts