Black Z-shape Rubber Weather Strip Seal Hollow Car Weatherstrip Window Door

The Detail of Foam Z-shape rubber seal strip

Material: EPDM

Color: Black, red, yellow and so on

Hardness: according to your requirement

Shape: Z-type

Placement on Vehicle: Left, Right, Front, Rear

Features:

1.Made with EPDM rubber, excellent flexibility 

and waterproof, good effect from abruptly cold to suddenly hot 

2.Specially designed Vehicle Sealed Strip can be used on side of car doors, boot, engine, 

low the win and the sound of vibration, also can be used on door frame, window, forbid collision

 in order to make the outside noise low.

3.You can re-user the original retainer of your car or waterproof double-side adhesive tape 

to install this weatherstrip. 

Please use oil/wax mover to clean the applied target before you install the weatherstrip

The Installation Steps

1.Wipe the stain

2.uncovered the 3M adhesive

3.Stick sealing strip

4.Cut off spare Parts

Installation method:

1:Before pasting ,paste parts deal with clean, do not have any stains and moisture 

2:After pasting to keep clean, do not suffer long against dirt and water,

otherwise it will lose tack 3 M tape effect, there will be off open plastic phenomenon.

3:Paste selected bits identify the paste will start from the front side door seal the lower end of the rod 

began to carry out a little pressed paste, be careful not to pull the seal a little action, 

try to keep the prototype seal slowly aligned identify the Paste the path carefully paste; 

position in the corner of the door frame, seal very gentle to pay attention to bend away type, 

do not bend too fast aesthetic impact. Figure fast not seek hurry, so as to ensure results.

4:after the check,All pasted were thoughtful and meticulous hand pressing it, you can call it a day, 

and this time it is best not to close, wide open doors on 20 minutes after a closed door

Then the best other 3 - 5 hours before normal use to open the door.

5:complete ban after pasting a hand to pull the seal ban car washing water on

in three days as much as possible not to repeatedly switch the door within 24 hours.

6:Construction of close will be a little tight, please do not worry, 

in the first 2-3 days when you can normal.

7:please everyone in 1-2 days time more attention to the door is not closed, safety first.

The place of installation

Specially designed Vehicle Sealed Strip can be used on side of car doors, boot,engine,low the win 

and the sound of vibration, also can be used on door frame, window, forbid collision 

in order to make the outside noise low.

You can re-user the original retainer of your car 

or waterproof double-side adhesive tape to install this weatherstrip.

Please use oil/wax mover to clean the applied target before you install the weatherstrip